The Anycubic Mono X LCD screen is considered a consumable of the 3D printer. The average lifespan is 2000 hours, which then needs to be replaced. Not sure how many hours I had with mine but it came time to change it. As I noticed some screen artifacts appearing.
Removing the Black tape seal covering the LCD screen
New LCD screen and parts
Tape removed, area cleaned ready to proceed
Metal screen removed
Lifting out the LCD screen and cleaning area
Removing front panel
Case open ready to proceed
Disconnecting LCD screen
LCD removed and Control board disconnected from the motherboard
Old LCD control board removed
New LCD control board and FPC flexible cable
Comparing old and new control boards
New control board wired to match old board
New control board in place. Actually the most difficult part of the process for me due to my hands was reconnecting this board to the machine.
New LCD screen inserted and wired
New LCD screen in place
Everything back in place ready to level
Believe it or not, this precision machine, printing layers .05 mm thick, is leveled with a piece of paper.
Build plate in home position on the leveling paper.
Tightening the Build plate into position